|
<< Click to Display Table of Contents >> Build 3.0.064 |
  
|
|
<< Click to Display Table of Contents >> Build 3.0.064 |
|
Release date: 5th May 2016
Fixes and improvements:
General:
| • | Changes to the way the built-in SpecView exception handling works |
| • | Colour Dynamics gives an error when using the German language |
Trend Charts:
| • | Some Trend Charts could lock-up while drawing if the Elapsed Time Axis was present and a T0 time had been set |
| • | Historical Replay of a Trend chart when a Pen wasn't fully defined could cause a hang and/or crash |
DDE:
| • | Occasional DDE crash when closing Excel |
Networking:
| • | Remote crash fixed when under heavy load. |
Modbus:
| • | When a TCP/IP converter returned Exception code 11 and the ECR and ECR2 codes were set this could cause a crash |
| • | Could not reliably download to parameters of type 'Time' which had a SON (ScalingOfNumbers) code, also the SON default TimeToLive (TTL) is now set to 60s |
| • | If there were numerous occurrences of NotCurrentlyAvailable (NCA), e.g. when Eurotherm segment data is unavailable, and comms was under very heavy load, then updates could take over 20 minutes |
| • | The driver was constantly attempting to re-connect to dead sockets even though 'Comms Backoff' had stopped requesting from those IP addresses |
| • | Occasionally when a TCP/IP socket was re-opened there could be a crash due to timing |
Watlow StandardBus:
| • | Driver fixes for multiple problems |