|
<< Click to Display Table of Contents >> Mitsubishi Q Series |
  
|
|
<< Click to Display Table of Contents >> Mitsubishi Q Series |
|
SpecView does not support the Q series natively.
However some Q series PLCs can take Modbus/RTU cards, which SpecView does support.
See Modbus Addressing for details on how to specify the instrument's address in SpecView
At the time of writing there are 2 ranges of Q series:
| o | Qn range |
| o | QnAS range |
The QnAS rack does allow it to take the A series cards. Therefore it should allow you to use either:
| o | A1SJ71UC24-R2-S2 - Modbus (ASCII + RTU) interface module, RS232C connection (slave) |
| o | A1SJ71UC24-R4-S2 - Modbus (ASCII + RTU) interface module, RS422/485 connection (slave) |
If you use either card it must be set to Modbus/RTU. The R2 is single-drop and the R4 multi-drop. At the time of writing we do NOT have any customers using either card and so cannot guarantee results!
The most uptodate information on the Mitsubishi Q Series
is available for download from our website
http://www.specview.com
Click on the 'Download' link, then click the link to the FTP site.
The most recent document is in the TechNotes folder.