Editing a SpecView Project > Full Screen Mode

Full Screen mode in Runtime is where a GDW fills the monitor's whole screen, there is no title bar or menubar across the top of the screen or Windows toolbar along the bottom of the screen.

It can be enabled/disabled by using these methods:

•	Setting Full screen mode from the Preferences - Display tab. This will cause Full Screen mode to be enabled automatically when entering Runtime Mode

•	Via the 'Toggle Full Screen mode' menu command on the File menu during Runtime

•	Via the 'Switch to Full Screen' menu command on the File menu during Historical Replay

However, once Full Screen mode has been enabled there will be no menus accessible, therefore a button should be added to the GDW to reverse the command with the action GDW Control: Toggle Full Screen Mode. (This button may be placed on another GDW accessed by GDW Control: Swap to another GDW).

NOTE: When this mode is enabled there are no menus accessible, therefore it is STRONGLY recommended to add a button somewhere on the GDW which has the action: GDW Control: Toggle Full Screen Mode. If there is no such button then SpecView will display a warning before exiting Edit Mode. However, there is an emergency method of getting out of Full Screen mode, read 'Magic Square' in Preferences - Display

Also note that when Passwords are used in conjunction with Full Screen Mode it is important to ensure that there are buttons on the GDW for Login and Logout.