<< Click to Display Table of Contents >> Navigation:  Editing a SpecView Project > SpecView Error Codes > SpecView Generic Error Codes

 

These are generic Error codes.  There are also Errors that apply specifically to writing variables to instruments.  They are listed here.

3        Timeout

1460        Timeout - Response not received from instrument (check the wiring connection)

10001        Cannot Open Comms - Port In use

10002        Cannot Open Comms - Port Setup Error

10003        Cannot Open Comms - Port Characteristics Error

10004        Failed Write

10005        Incorrect Baud Rate

10006        Cannot Initialize Windows Comms Subsystem

10007        Cannot Save Project

10008        Cannot Start System Timer

10009        Cannot find Folder

10010        Invalid Parameter

10011        Invalid Function

10012        Address Out of range

10013        Data Out of Range

10014        Parameter Write protected

10022        Cannot Find Required DLL - If this error code is given with a message about TCP/IP; then check the IP address that is selected on the Preferences - Remote tab.

10023   Historical Replay: There is no logged data for the day specified

 

Program Launch Failed; WExec error code = 2

This error will occur when the SpecView: Run External Program action is being used to launch a program for which the file name has been incorrectly specified. Similarly:

WExec error code = 3     - The path for the file has been incorrectly specified.

WExec error code = 11   - The file specified is not in valid EXE file format.

 

18000 - 18199 Write Errors

18200 - 18500 Protocol Specific Error Codes

20000 - 21000 Error codes from the Local computer when using SpecView Networking.

 

Specific error codes:

20022   This error is shown in the Event Window when a Remote connection has failed because the versions of SpecView running on the Local & Remote are not compatible. Please update them accordingly.

 

32002 This error is shown when using SpecView Remote to connect to a Local which has not had the networking server started from Preferences. This is detailed in Setting up SpecView Networking

This can be confirmed by using the menu command View Connected Users from the Local's Remotes menu during Runtime mode, which would show ''Server NOT Running'

 

84036 (and values above) These are OPC errors when the value being returned from the OPC server cannot be relied on. In this case please contact your OPC Server supplier.